The meter does not show in the list:
- Check that Bluetooth is on in your phone. If it is off, the app shows Please turn on Bluetooth.
- If the app shows Bluetooth access needed, open your phone’s settings, find Pool Service Software, and allow Bluetooth (and Nearby devices on Android).
- Check that the meter is on and its Bluetooth is enabled.
- Pull down on the Choose Digital Meter list to scan again.
- Bring the phone close to the meter.
- Make sure no other app (such as LaMotte’s own app) is connected to the meter. A meter talks to one app at a time. Close the other app and scan again.
- If you paired the meter in your phone’s Bluetooth settings, remove (“forget”) it there and scan again from PSS.
Connected, but no readings arrive:
- Spin Touch: tap Send on the meter’s results screen. PSS does not pull results on its own.
- ColorQ 2X: press the button to go to the next test. That is what sends the current result.
- Tap the meter in the list again to reconnect. The app shows Device Disconnected when you disconnect, then the check mark when it reconnects.
A reading did not fill in:
- That reading may be hidden for your company. Ask your office to show it on visits.
- The test may not have a matching PSS reading (see the table in 31.1). Type it into a custom reading if your office set one up.
Still stuck? Type the readings in by hand so the visit is not held up, then contact PSS support with the meter model and your phone type.